Meaning
The amount of water absorbed into a polymer matrix before processing affects the mechanical strength and surface finish of the molded part. Resin moisture content is measured as a percentage of total weight using specialized moisture analyzers. Hydroscopic materials like nylon or polycarbonate require drying to levels below 0.02 percent to avoid hydrolytic degradation.
Processing material with excess water causes internal structural defects and visible silver streaks on the part surface.
Material Degradation
Water molecules at high temperatures react with the polymer chains to reduce the molecular weight of the material. This loss of chain length results in a lower resin moisture content than is safe for structural applications. Impact resistance and tensile strength drop when the polymer bonds are severed by steam expansion within the barrel.
Such damage is irreversible and cannot be corrected by later annealing or cooling. Brittle failure occurs when the degraded part is placed under mechanical load in the field.
Measurement Protocol
Loss-on-drying instruments or Karl Fischer titration provide the precise data needed for compliance with ISO 15512. The resin moisture content must be sampled directly from the press hopper rather than the dryer discharge to account for re-absorption during transport. Samples are heated until no further weight loss occurs, indicating that all water has been evaporated.
This measurement verifies that the drying equipment is operating at the correct dew point.
Process Limit
Production specifications define the maximum allowable moisture level for each specific resin grade. If the resin moisture content exceeds this limit, the molding process must stop until the material reaches the dry state. Over-drying also presents risks such as oxidation or thermal degradation of the additives.
Monitoring the moisture level ensures that the material properties remain within the validated design window.