Meaning
Build up of circuit patterns through selective plating on a thin conductive base allows for higher density circuit designs than traditional etching methods. In a typical msap metallization sequence, a thin seed layer is chemically deposited before a photoresist mask defines the circuit paths. This approach enables the production of fine lines with vertical sidewalls, which are necessary for high frequency 5G applications.
Additive Sequencing
Precise control of levelers and brighteners ensures that the copper grows uniformly within the narrow resist channels. While the seed layer provides the initial conductivity, the electrolytic step provides the bulk of the circuit height.
License Requirement
Factories utilizing the modified semi-additive process must update their Pollutant Discharge Permit to specify the etching chemistries used for seed layer removal. The Ministry of Ecology and Environment monitors the copper concentration in the wastewater from these etching lines. Because the process uses thinner copper foils, the volume of metal removed per panel is lower than in subtractive processes, potentially easing wastewater treatment loads.
However, the use of specialized chemical palladium catalysts requires a separate hazardous material handling license. This requirement is non-negotiable.
Pattern Accuracy
Reducing the undercut effect during the final flash etch stage preserves the intended line width of the circuit. High yields depend on the perfect adhesion between the plated copper and the seed material.