Meaning
Mechanical test procedures in semiconductor manufacturing measure the force required to rupture a microscopic wire connection between a silicon die and its package. This diagnostic assessment, known as wire bond pull, is the primary method used to evaluate the mechanical integrity of electrical joints. The test is performed by placing a hook under the wire loop and pulling vertically until failure occurs.
Its application is limited to wire bonds that have sufficient loop height to accommodate the test hook without damaging the surrounding structure.
Physical Test
Automated test equipment executes the pull sequence by raising the hook at a controlled rate while recording the applied force. The peak force achieved before rupture is recorded as the pull strength. These measurements are taken across a sample of devices from each production lot to monitor process stability.
If the recorded forces fall below a specified threshold, the assembly line is stopped for investigation.
Failure Mode
Analyzing the location and appearance of the break provides information about the assembly process. Failure can occur at the wire itself, at the interface of the first bond on the chip, or at the second bond on the leadframe. Joint failures often indicate contamination on the pads or incorrect bonding parameters.
Quality Standard
Industry standards like MIL-STD-883 define the minimum acceptable pull forces based on wire material and wire diameter. Gold and copper wires have different minimum thresholds due to their distinct mechanical properties. Factories use these standards to establish statistical process control limits that prevent marginal parts from being shipped to customers.
Regular calibration of the test equipment is required to maintain the accuracy of the force measurements.