Meaning
A mechanical wear mechanism in high-density printed circuit boards occurs when multiple microvias are aligned vertically on top of each other. This condition, known as stacked microvia fatigue, is caused by the difference in the rate of thermal expansion between the copper plating and the surrounding fiberglass material. When the board undergoes repeated thermal cycles, it generates mechanical stresses that can crack the copper connections.
The damage accumulates over time, leading to intermittent signal failures or complete circuit interruption, which can compromise the reliability of the entire system. This failure mode is a major concern for aerospace and automotive electronics.
Stress Generation
During temperature changes, the fiberglass substrate expands vertically faster than the copper microvia structure. This difference puts the microvia under intense tension when the board heats up. In stacked configurations, the concentration of force makes the design highly vulnerable to failure.
Failure Mode
Cracking usually occurs at the boundary where the copper fill of the upper microvia meets the target pad of the lower microvia. This separation can be very small, often closing when the board is hot and opening as it cools. Consequently, the fault is difficult to detect during standard factory testing because the connection may appear normal at room temperature.
The fault often shows up only after the product has been deployed.
Mitigation Strategy
Designers can reduce the risk of failure by using staggered microvia layouts instead of stacked structures. In staggered designs, the vias are offset from each other, which distributes the thermal stress more evenly through the board. Another approach is to use materials with a lower coefficient of thermal expansion for the board substrate.
This design choice helps prevent stress from building up during thermal cycles.