Meaning
Structural durability calculations use a cumulative approach to predict the point at which a mechanical component will fail under varying stress levels. The principle of linear damage summation assumes that every cycle of stress uses up a specific fraction of the total fatigue life of the material. When the total of these fractions reaches unity, the part is theoretically expected to undergo catastrophic failure or visible cracking.
Cumulative Strain
Fatigue cycles at high stress intensities consume the life of a component much faster than cycles at low stress intensities. In engineering practice, linear damage summation treats each load block as an independent contribution to the total wear. This method simplifies the analysis of complex loading histories such as those found in vehicle suspensions or aircraft wings.
Fatigue Prediction
Engineers apply the S-N curve of a material to determine the number of cycles allowed at each discrete stress amplitude. By dividing the actual number of cycles experienced by the maximum allowable cycles, the value for linear damage summation is obtained for that specific load. The total damage is the simple addition of these ratios across all operating conditions.
Operational Limit
Safety factors are applied to the final result because this model does not account for the sequence in which loads are applied. While linear damage summation provides a quick estimation, real-world components often fail earlier if high loads occur at the very beginning of the service life. Maintenance intervals are usually set at a fraction of the predicted life, such as zero point five or zero point six, to provide a margin against material variability.
Testing verifies that the prediction holds across different batches of raw material used in the factory. This approach allows for the scheduling of inspections before cracks reach a size that could lead to the loss of the entire assembly.